Home > Knowledge > Content
Production process and storage requirements of aquatic feed granulator
- Nov 13, 2018 -

In the process of using the aquatic feed granulator, the new machine is run-in, take out 3-10 kg of mixed powdered feed to a certain extent, add 10% edible oil and mix thoroughly, and open the oil block by hand. First add the feed, start the machine and adjust the pressure roller bolt with a wrench until the normal discharge.

 

In the process of production of the aquatic feed granulator, the oily feed is repeatedly squeezed 3-5 times in the machine, and then gradually added dry material. (After the oiled feed is squeezed, it cannot be used for rabbit feeding. After the new machine is worn again, it does not need to be worn again later).

 

After adding the dry material, if you hear the mechanical boring, you should loosen the pressure roller bolt a little and release it normally. If the oiled material is not pressed out, or the dry material is placed, the pellet machine does not discharge, and the steel nail is used to expose the feed in the mold plate (the steel nail is flattened), and then re-run.

 

Adjustment of the feed length of the aquatic feed granulator.

The length of the pellets is adjusted by adjusting the cutter provided on the side of the discharge port.

Storage of aquatic feed granulators.

The processed pellets have a relatively high temperature and should be placed in a ventilated place.http://www.china-hqpelletmill.com/