Home > Knowledge > Content
Length adjustment and storage of modular feed pellet mill
- Jan 31, 2019 -

In the process of using the modular feed pellet mill, first take out 3-10 kg of mixed powdered feed, add 10% edible oil and mix thoroughly, and open the oil block by hand, first add the feed, start the machine with a wrench adjust the pressure roller bolts until the normal discharge.

The oily feed is repeatedly squeezed 3-5 times in the machine, and then gradually added dry material. (After the oiled feed is squeezed, it cannot be used for rabbit feeding. After the new machine is worn again, it does not need to be worn again later).

After adding the dry material to the modular feed pellet mill, if you hear the mechanical smoldering, you should loosen the pressure roller bolt a little and release it normally.

If the oiled material is not pressed out, or the dry material is put on, the pellet machine does not discharge, and the steel nail is used to expose the feed in the mold plate (the steel nail is flattened), and then re-run.

Adjustment of feed length.

The length of the pellets is adjusted by adjusting the cutter provided on the side of the discharge port.

Storage of feed pellets.

The processed pellets have a relatively high temperature and should be placed in a ventilated place and stored in a bag when cooled to room temperature.